Hi experts for the past few days i have been observing that clients who do not have internet access are stealing ip addresses which have internet access and using them for internet purposes. I have ACL configured permitting and denying ip protocol for some ip addresses only. I want to use 48 bit mac address ACL so that i can deny internet access mac address based, i know this is possbile but i would really appreciate if configuration steps are listed down which will save my time and ease work for me. As in IP, ffff.ffff.ffff is broadcast addres, 0.0.0 is network address.

Any means any address. As they can't be binded to NIC, I'm used to add those to mac-acl's In that direction You want to block users, it should work without it. So Your config should work, hence propably will fail due to syntax error. Use mine without broadcast/network addresses. And remember, that each ACL has default 'deny' statement at the end (unless specified otherwise with 'default' command) interface fa0/1 mac access-group internet in means apply the mac-acl to the port of the switch.

Displaying Dynamically Applied Ip Acls For Mac Free

This mac-acl will guard only this switchport. Hence You can apply same acl to many ports. You may list as many MAC You want, but all they have to be permitted to access any (otherwise access-group would fail).

This is called Cisco security or so, but it's simple cisco shortcomming. Sorry, not my fault. Hi raven sorry for replying so late i was on a vacation just goin through the steps u mentioned and was getting little confused on some things like for eg in the configuration steps u listed u say permit host xx.xx.xx.xx any and therez a default deny statement at the end this will probably from what i feel will allow the host to access everythg right if am right can i insert a deny instead of a permit and say permit any at the end coz my main moto is to block one mac from accessing the internet and allow everythg else on the local network. Or is it the cisco way of looking into security where u say permit any and deny in the end please clarify.

. All I get is 'this setting is run by your adminin strator' and no ability to access admin settings. Windows have still not given me a solution. Hi - I know this is an older post but I'm wondering if this will still be valid today?

I am new and not sure where to put this, but this is specific to an image gallery on a single page, not all. Rob Still does it. Die Chrome.

It didn't work with Windows 7, but did point me in the right direction. I used EaseUS Partition Manager (free download and install) and used that to delete all the PS4 partitions and reformat the.

it worked thanks!